1.38

You are here:

Additions:

  • It is now possible to adjust the smoothing of the FLOATSOFT solver algorithm to improve performance and reduce the number of failed solutions. The slider to adjust it can be found in Settings window. Increase this slider if FLOATSOFT jerks the hull model around, decrease if you get “no solution” errors.
  • FLOATSOFT will now color results in red if some of them are not valid to make a clear visual indication.
  • One additional report – Sink Rate. Displays approximate sink rate of the vessel, expressed in displacement units per length units, calculated based on waterplane area.

Changes:

  • Minor GUI restructuring. Simulation attempt limit in the Settings window has been renamed to Solver attempts, because the solver is now used throughout the application, not just in Simulation mode.
Previous 1.39
Next 1.37
Table of Contents